Laser Installation And Adjustment Steps For The Computer Board Of The U-885 Car Balancing Machine
1.Install the new laser on the shaft / connect the cable to the computer board
2.Press “STOP” and turn on the machine/press “M” to laser setting/press “E” to enter laser setting
3.Hang the reference object on the shaft / rotate the laser to the reference object center
4.Swing the laser bracket / make the laser point coincide with the center of the reference object
5.Tighten the laser bracket Note: KEEP 2-3mm between the laser bracket and machine body
6.Press “ALU” to the next step
7.Move the reference object to the shaft outside / check the laser point position / adjust the motor make laser point on the reference object
8.Press “STOP” to exit
9.Reenter laser setting
10.Measure the distance between the laser point and machine body: up and down
If the up distance is big please adjust the circuit board down a little
Note: if the down distance is big please adjust the circuit board a little upper
Reenter laser setting and check the laser point
Make sure the up and down distance between the laser point and machine body should keep the same value
11.Put on the cover/press “ALU” and “STOP” to exit/install tyre on the machine
12.Input the tire data
13.Enter laser setting
14.Press “ALU” twice
15.Measure the distance between the laser point and the shaft/input the calculated data (measure data + 31)
16.Press “ALU” to the next step
17.Press b+ or b- adjust the laser point to the position where the measuring ruler put
18.Press “ALU” to the next step
19.Put down the protective cover to start the machine
20.Rotate the tire to the specified position / add 100g at 12 o’clock on the tyre inside
21.Put down the protective cover and start the machine
22.Rotate the tire / make the laser point in the middle of the 100g counterweight
23.Press “ALU” to finish laser setting
The automatic wheel balancer for professional use with laser positioning system and LED light.
Equipped with TFT color monitor and 2 electro. Sensor arms for rim width and diameter measurement as well as an auto. program detection(Normal and Alu-S)
New: The U-885 has a laser positioning system for precise positioning of adhesive weights at 6 o'clock position (also possible at 12 o'clock position without laser). LED light for better visibility.
The U-885 has a 40 mm shaft and an extended wheel mount for wide rims, e.g. Porsche, SUV, etc.
In addition, the machine is fitted with a foot brake for fixing the shaft during balancing.
Help functions are displayed on the monitor.
Measuring arm with optical/acoustic operator guidance.
1.Top built quality with CE-certificate, Manufactured according to ISO 9001;
Laser positioning system at 6 o'clock position;
LED light for better visibility;
4.Measuring arm determines the width of the wheel;
5.Splitting program enables the precise placement of hidden weights, behind the spokes
6.Electronic sensor arm;
Large TFT-Colour monitor;
8.Measured values are shown when the wheel brakes;
9.Static and dynamic balancing;
10.Several available programs Normal / Static / Alu1, Alu2, Alu3 Motorcycle, etc.;
Integrated calibration and self-diagnostic program;
12.Optional: Motorcycleadapter, Adapter for vehicles without center hole.
||252-610 mm 10"-24"
||40-510 mm 1.5"-20"
|Split and hidden weight solution
|Max. wheel weight
||65 kg (143 lbs)
|Power supply voltage options
|| 110v (1ph)/ 220v (1/3ph)/380v(3ph)
|Option motor power
|| < 70dB
||102/123kg (225/271 lbs)